Create a block diagram using SIMULINK and run the model for four different values of the dampening coefficient P: P = 0, 4, and 30 N s/m. Use a simulation time of 10 seconds and a maximum step size of 0.01 sec
Create a block diagram using SIMULINK and run the model for four different values of the dampening coefficient P: P = 0, 4, and 30 N s/m. Use a simulation time of 10 seconds and a maximum step size of 0.01 sec. Submit one block diagram (for the case of P = 4) and three scopes, one for each value of P. Briefly analyze the results.
(2) You set up the block diagram for problem 6.7 on your homework and calculated (by hand) the ultimate positions of the masses. Now, simulate the system using Simulink.
Submit a block diagram for the system. Submit a scope in which the positions of each mass are plotted versus time on the same graph.
Estimate the ultimate positions of the two blocks from your graph and compare them to your hand calculation from the homework.
Run the simulation for 10 sec with a max step size of 0.01 sec.
How it Works
1
It only takes a couple of minutes to fill in your details, select the type of paper you need (essay, term paper, etc.), give us all necessary information regarding your assignment.
2
Once we receive your request, one of our customer support representatives will contact you within 24 hours with more specific information about how much it'll cost for this particular project.
3
After receiving payment confirmation via PayPal or credit card – we begin working on your detailed outline, which is based on the requirements given by yourself upon ordering.
4
Once approved, your order is complete and will be emailed directly to the email address provided before payment was made!